N1MM+ HotKeys and TS450 Control - Printable Version +- W1NRG Forum (https://www.w1nrg.com/forum) +-- Forum: General Discussions (https://www.w1nrg.com/forum/forumdisplay.php?fid=10) +--- Forum: Interference, RFI and Technical (https://www.w1nrg.com/forum/forumdisplay.php?fid=30) +--- Thread: N1MM+ HotKeys and TS450 Control (/showthread.php?tid=380) |
N1MM+ HotKeys and TS450 Control - K1RCT - 12-20-2014 If you use N1MM or Plus version & use the Logger Hot Keys for CQ (Running or S&P responses) (without a Keyer): 1) How do you control the PTT ? 2) How is the audio connected to your rig? Thinking my TS-450S AT needs something like WinKeyer USB. I presently use Signalink USB for digimodes and tried using it for Rig Control during N1MM+ Hotkey messages when running - nogo. RE: N1MM+ HotKeys and TS450 Control - N1API - 12-20-2014 (12-20-2014, 11:43 AM)KC1ACN Wrote: If you use N1MM or Plus version & use the Logger Hot Keys for CQ (Running or S&P responses) (without a Keyer): The 450 is the same as the 690S in setup at the club. If you use the same setup as they used last week in ARRL 10 M it should work. I am not sure what interface they used for CW but I don't think that you need any thing other than the correct wire from either your USB port or Parallel printer port, (for computers that have one), or possibly a serial Port. Check on the N1MM Yahoo list and ask and you will probably get a ton of responses. Al RE: N1MM+ HotKeys and TS450 Control - K1RCT - 12-20-2014 Thanks for responding AL. Found my answer. One setting under the config. panel, Rig Control/TS450 setting, I had to check the PTT Controlled by Radio Command. Now my Signalink works perfect. Nice long run today on 15M. RE: N1MM+ HotKeys and TS450 Control - N1API - 12-21-2014 (12-20-2014, 10:15 PM)KC1ACN Wrote: Thanks for responding AL. Found my answer. That's GERRRR_ATE! |