KB1YFJ
I went and got the cord to connect my Kenwood to my computer, I went through the manual for the Kenwood and set up the Kenwood as the manual said. Then I set up the WSJT-X the way that instructions said, when I do the test to see if it will connect I get Hamlib error: Communication timed out. Anyone have any idea what I am doing wrong?
You will need more than a single cable to get the TS-2000 to work with one of these digital modes like FT8. I have a TS-2000 and a home brew interface box (my version of a rig blaster). I've included the block diagram for that. I've been using this since 2014 but recently rebuilt it and placed in a nicer enclosure. If you have a rig blaster, that would work too. There will probably be a segment in KK soon on this project.
I've also included my settings for JTDX which is a fork from WSJT-x (uses the same settings).
Drop me a note if you get stuck.
[attachment=270]
[attachment=271]
[attachment=272]
[attachment=273]
73,
Steve
KC1SA
I went and got the cord to connect my Kenwood to my computer, I went through the manual for the Kenwood and set up the Kenwood as the manual said. Then I set up the WSJT-X the way that instructions said, when I do the test to see if it will connect I get Hamlib error: Communication timed out. Anyone have any idea what I am doing wrong?
You will need more than a single cable to get the TS-2000 to work with one of these digital modes like FT8. I have a TS-2000 and a home brew interface box (my version of a rig blaster). I've included the block diagram for that. I've been using this since 2014 but recently rebuilt it and placed in a nicer enclosure. If you have a rig blaster, that would work too. There will probably be a segment in KK soon on this project.
I've also included my settings for JTDX which is a fork from WSJT-x (uses the same settings).
Drop me a note if you get stuck.
[attachment=270]
[attachment=271]
[attachment=272]
[attachment=273]
73,
Steve
KC1SA
73, Steve - KC1SA